Thursday, April 17, 2008

Experiment 4

Objects In Motion Remain In Motion
Group Members:
Physicist: Blair Robinson
Physicist: James Fisher
11-1
4/15/08

Objective: To experiment Newton’s first law has to do with the force required to change speed or direction of a moving object. It will take more force to change the speed or direction of a moving object than it does to maintain the initial speed of the object.

Hypothesis: I think the force will be greater to increase the speed of the cart. I also think the speed of the cart when you move it in the shape of the arc will decrease. The force required to maintain the initial speed of the cart would decrease.

Materials:
Hall’s Cart
200-gram mass
Spring scale
String

Procedure:
1. Use the same setup from experiment 2.
2. Start moving at a slow speed by pulling on the string scale.
3. Then quickly pull harder to accelerate the speed of the speed. Repeat 4-5 times while reading the scale.
4. Start rolling slowly by pulling on the spring scale and then pull the scale in a wide arc to change the direction of the cart. Repeat 4-5 times.
5. Record the maximum force for both.

Data:
Trial
Start Finish
1. .5n 1n
2. .5n 5n
3. .5n 2n
4. .5n 2n
5. .5n 1.5n

Trial
Start Finish
1. .5n 2n
2. .5n 2n
3..5n 4n
4..5n 4n

Conclusion:
It takes more force to accelerate the cart and it takes less force to maintain its initial speed. It also takes less force to change the direction of the cart and more force to maintain the direction of the cart. My hypothesis was both right and wrong. It takes more force to maintain the direction of the cart instead of less force. If I could change the lab, I would move the cart in many directions to see if the force increase or decrease. I would also have a better way to measure the force. I learned the more force the faster the object will move. The concept can be used in everyday life because it shows how you should use seatbelts in cars to stop a person from being jerked around.

Experiment 3

Objects In Motion Remain In Motion
Group Members:
Physicist: Blair Robinson
Physicist: James Fisher
11-1
4/15/08

Objective: To test Newton’s first law with respect to objects in motion. Objects in motion will stay in motion unless acted upon by an external force.

Hypothesis: I think the 100-gram mass will not fly off the hall’s cart. I think it will just move or not move at all.

Materials:
Hall’s Cart
100-gram mass
Cardboard
Wooden ramp

Procedure:
1.Place the wooden ramp on the floor.
2.Tape a piece of cardboard over the hole in Hall’s Cart.
3.Put the 100-gram mass on top of cardboard.
4.Gently push car so it hits the edge of the ramp. Repeat 4-5 times.

Data:
Trial:Mass
1.Mass moved
2.Mass moved
3.Mass flew off
4.Mass moved
5.Mass moved

Conclusion:
My hypothesis was both correct and in correct. It was correct because the 100-grams did move. It is incorrect because it didn’t stay still and it did fly off the cart. If I could change the lab, I would of use the material differently. I would have taken the cardboard off to see if the mass would move the same ways. To better the results I would move the cart at different speeds to see how the mass would move. I learned that when an external force interferes with an object it makes that object move in different directions. The concepts can be use in everyday life because it shows what will happen if something is push with being protected which can help with babies I strollers.

Wednesday, April 16, 2008

Experiment 1

Objects at Rest Remain at Rest
Physicist:Marquisa Howard
Group Members Physicist James Fisher Physicist Blair Robinson
Section 11-1
April 16, 2008
Objective: The problem statement for this experiment is "An object at rest remain at rest unless acted upon by external forces.”
Hypothesis: I believe the cart will roll of the ramp instead of dropping straight down.
Materials: A wooden ramp, a cart, and table.
Procedure:
1.Set the wooden ramp on the table with 12” of the ramp extending over the edge of the table. 2.Place the hall’s cart on top of the ramp. The cart at this point is in a state of rest.
3.Standing to one side quickly jerk the ramp out from underneath the halls cart. Try this four to five times record observations.
Experiment 1:
Trail 1-Rolled forward and stopped on the table
Trail 2-Rolled back and stopped on the table
Trail 3-Rolled forward and stopped on the table
Trail 4-Rolled forward and stopped on the table
Conclusion:My hypothesis was correct. If i could change something about the lab i would pull the ramp of a different object.

Experiment 2

Objective: Greater force is required than regular force
Hypothesis: I think the force to change the direction will be less.
Materials Used: 8"inch string, wooden ramp, 200 gram mass, cart spring scale
Procedure:
1) Cut a piece of string about 8" long. Tie one end to the front of the Hall's cart and tie a loop in the free end.
2) Put the 200 gram (g) mass in the Hall's cart.
3) Push the cart back and forth on the table and think about the problem statement. Write down your hypothesis before you begin the procedure.
4) Zero the spring scale and attach the hook on the spring scale to the string loop on the cart.
5) Tug on the spring scale several times to start the cart moving from rest. Note and record the spring scale reading each time.
6) Now pull on the spring scale several times to rapidly start the cart moving from rest. Note and record the spring scale readings.
7) Finally, pull the cart across a table or floor at a constant speed several times. Note and record the spring scale readings each time. Try this step again, pulling the cart at a faster speed and record your results.
Data:
When pulled:
Trial 1- 0n and 0g The object was at rest
Trial 2 - .5n and 50gThe object moved slightly
Trial 3- 1n and 100gThe object wheels rolled two times
Trial 4- 1.5n and 150gThe object crashed into the spring
Trial 5- 2n and 200gThe object crashed into the spring
Conclusion: My hypothesis was correct it took less force. To improve this lab i would used more force and change the direction it was going in.